Cusack Music Cable Tester - Cable Continuity Tester
Solderless cable has become very popular in recent years. The convenience of being able to just screw a cable together is not without it’s downfall, however. Getting a nice solid connection using the pins and set screws most brands use can be difficult. This causes a resistance in the cable that works with the capacitance present in every cable to create a low pass filter, rolling off your high end. Many people use a simple continuity tester to test their cables. While a cable may test good in this manner, it may have excess resistance, something the continuity tester is not checking. An ideal cable will have less than 1O between it’s ends. One could use an ohm meter to check the cable, but fumbling around with meter leads can be tricky. The Cusack Music Cable Tester is the perfect device to make sure you have a good cable.
Using the Cable Tester is simple. First, plug in power. Next, flip the switch to “Calibrate”, and adjust the knob until the green LED turns off, then back until it just comes on. Flip the switch back to “Use”, and you are ready to start testing cables. Plug each end of the cable into the tester until it clicks once. This tests the tip of the cable. If the light stays on, there is less than 1 Ohm of resistance, and you are good to go. Push one end of the cable down a second click, and you are now checking the ring to tip connection. The LED should turn off. Plug the other end in to the second click, and you are testing the ring connection. Repeat this for the third click, which is the sleeve.
Small, easy to use, and handy to have, the Cusack Music Cable Tester is the perfect addition to every musician and technician's tool set.
-Standard center negative 9V DC supply (not included)
-Current draw: ~3mA
-3.66" L x 1.52" W x 1.24" H
"Hey! I bought a blem Cable Tester from your Reverb shop last week and I LOVE it! I've used a few different kinds of solderless cable for my pedalboard and I've always had issues with my cables. I was about to spend a ton of money on getting new soldered cables when I found your cable tester. I used it last night to rewire my whole board, and because of the cable tester I was able to do it way faster and with ZERO problems after it was done. Everything sounds and works perfectly. Just wanted to give you guys a shout and tell you THANK YOU."
"Wow! This is the best thing I've purchased in awhile. I've been using George L's for 10 years and though I thought my cables were all good, it has shown me how much tone I was missing out on. Truly tells me if my cable is not perfect where my other tester said they were fine. Thanks for the great product!"
-Jeff Z.Health and Safety:
-WARNING (click for more information)